This unit (MEM05012) of competency defines the skills and knowledge required to carry out routine manual metal arc welding (MMAW) of low carbon mild steel where the welding is not required to meet an Australian Standard or equivalent.
Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.
Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.
Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations, should also be selected as appropriate.
No licensing, legislative or certification requirements apply to this unit at the time of publication.
Unit details
Location:
Study level:
Vocational and further education (TAFE)
Unit code:
MEM05012
Prerequisites
MEM11011 - Undertake manual handling
MEM13015 - Work safely and effectively in manufacturing and engineering
MEM16006 - Organise and communicate information
Contact VU Polytechnic
Find a different unit
Assessment
Assessment tasks will be designed to reinforce and extend knowledge and skill competence within set and controlled parameters in accordance with each unit's learning outcomes and performance criteria requirements, including the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.
Students will be expected to demonstrate the following required skills:
- following work instructions, standard operating procedures (SOPs) and safe work practices;
- identifying and interpreting specifications from drawings, sketches and verbal or written job instructions for performing routine manual metal arc welding (MMAW);
- cleaning and preparing materials to specifications;
- setting up welding equipment, selecting appropriate electrodes and adjusting settings to suit application;
- welding materials to comply with specifications, and;
- cleaning welds for slag and splatter in accordance with SOPs.Students will also be expected to demonstrate the following knowledge:
- safe welding practices and procedures and use of personal protective equipment (PPE);
- material and equipment preparation;
- equipment set-up and settings;
- appropriate welding consumables consistent with standard operating procedures, and;
- MMAW processes and properties.
Where to next?
As part of a course
This unit is studied as part of the following courses. Refer to the course page for information on how to apply for the course.
VU takes care to ensure the accuracy of this unit information, but reserves the right to change or withdraw courses offered at any time. Please check that unit information is current with the Student Contact Centre.
